A
ahwe
Guest
I anticipate running sound out of my PC to a high-end pre-amp and amplifier cluster. The preamp is a strict dual mono design. Specs fall below this message.
My question is this -- can the Turtle Beach Santa Cruz handle the conversion from digital to dual mono directly? If not, will I need an additional piece of hardware? Is there a better, studio quality quality soundcard with an external box I should go after? I've seen recommendations for the Midiman Delta 1010, Terratec EWS88mt, and so on. Folks' thoughts greatly appreciated.
Specs on the pre-amp:
THD -120dB for the AD 797
DC to 1 Mhz -3dB
Output 27 volts
slew rate 2000 V/us for the BUF 634
Input noise voltage .09 V/sqr Hz and 4nV/sqr Hz for the BUF 634
Wide x long x tall
25 cm x 15 cm x 20 cm
6 dB gain for the line amplifier which should drive any amplifier to its maximum output power
My question is this -- can the Turtle Beach Santa Cruz handle the conversion from digital to dual mono directly? If not, will I need an additional piece of hardware? Is there a better, studio quality quality soundcard with an external box I should go after? I've seen recommendations for the Midiman Delta 1010, Terratec EWS88mt, and so on. Folks' thoughts greatly appreciated.
Specs on the pre-amp:
THD -120dB for the AD 797
DC to 1 Mhz -3dB
Output 27 volts
slew rate 2000 V/us for the BUF 634
Input noise voltage .09 V/sqr Hz and 4nV/sqr Hz for the BUF 634
Wide x long x tall
25 cm x 15 cm x 20 cm
6 dB gain for the line amplifier which should drive any amplifier to its maximum output power