mpc 2000 clasic user!!!

R

rinnegan

Guest
the problem i have is, i have a small sample a few senconds!!
and i try to trim, and it takes for ever to spin the data wheel
..is their any other way but faster ?

i hear the outer wheel but i spin and dont work..

i know i can use the number keys, but its too slow..

anybody help,,
 
I'm not sure if shift + note variation slider works on the classic, but it could.

Another way is to move your cursor over the start or end point parameter, and press shift + cursor left once or twice. That way you'll be able to scroll it faster with the data wheel. For fine adjusting, you'll of course need to set it back by either moving your cursor or using shift+cursor right.
 
jyri said:
I'm not sure if shift + note variation slider works on the classic, but it could.

Another way is to move your cursor over the start or end point parameter, and press shift + cursor left once or twice. That way you'll be able to scroll it faster with the data wheel. For fine adjusting, you'll of course need to set it back by either moving your cursor or using shift+cursor right.
Click to expand...

The slider don't work

and I'll try the other way hopefully it does work
thanks you very much and
god bless
 
Nope it didn't work I tried the shift + cursor

And it didn't :'s

can anybody else help?
 
rinnegan said:
Nope it didn't work I tried the shift + cursor

And it didn't :'s

can anybody else help?
Click to expand...

Ok, that's probably an XL addition too then. The data wheel should be better in the classic. Do as you were adviced to do in the other thread on the Getting Started section..
 
You must log in or register to reply here.
Back
Top