EnBeez the EmCee
New member
Hey guys, About 2 months into producing still a NEWB But just picked up the new Maschine studio to try out for a bit. Just switched from Logic X where I was using an MPK midi keyboard.
I can't figure out for the life of me in this software/hardware how to do some of the simple tasks in it that i could do In logic in about 2 seconds. So maybe you can help me because NI forum is not working for me and I can't find these by searching.
So What I usually do Is load the sample in and either make my loop or chop it up... (For this beat I'm doing right now it is just a 4 bar loop)
I have the 4 bar loop in the sample window, How do I make it loop so I know exactly where to have my start and end points... I See if I change into "Zone" There is a thing that says loop mode that I turn on but it does not change anything or loop it just plays throughout and stop.
In the sample window How do I "SKIP" Through Playhead. Like in logic i can use my arrows to skip through the sample to find pieces I like while It is playing, I can Only seem to play it from the very beginning with machine and have to listen to the entire loop to see where i want to chop.
And Finally probably the most ridiculous one...... I have a sample in a 4 bar loop or so how do I figure out the BPM so I can change the master tempo and how do I make the 4 bar loop actually play in the arrangements NOT the sample window...
These tasks all seem very very simple but I cannot figure them out on this new hardware ... thanks in advance
I can't figure out for the life of me in this software/hardware how to do some of the simple tasks in it that i could do In logic in about 2 seconds. So maybe you can help me because NI forum is not working for me and I can't find these by searching.
So What I usually do Is load the sample in and either make my loop or chop it up... (For this beat I'm doing right now it is just a 4 bar loop)
I have the 4 bar loop in the sample window, How do I make it loop so I know exactly where to have my start and end points... I See if I change into "Zone" There is a thing that says loop mode that I turn on but it does not change anything or loop it just plays throughout and stop.
In the sample window How do I "SKIP" Through Playhead. Like in logic i can use my arrows to skip through the sample to find pieces I like while It is playing, I can Only seem to play it from the very beginning with machine and have to listen to the entire loop to see where i want to chop.
And Finally probably the most ridiculous one...... I have a sample in a 4 bar loop or so how do I figure out the BPM so I can change the master tempo and how do I make the 4 bar loop actually play in the arrangements NOT the sample window...
These tasks all seem very very simple but I cannot figure them out on this new hardware ... thanks in advance